How to Make Hash Oil – Directions (Preparing the Extractor)

By now you probably already have all of the supplies prepared and have a good idea of what everything is for and how it will work. This will explain the step by step process you will have to follow to make the hash oil from your marijuana plants.

Step 1

Drill a little hole in the middle of one of the end caps for the pipe you are using. The hole only has to be big enough to fit the nozzle which supplies the butane.

Step 2

Drill around five holes all near the middle of the other end cap. The result will be comparable to the holes on a pepper shaker. This is where the hash oil gets collected from.

Step 3

Once you place a coffee filter in the pipe to make sure none of the material from your dope plants escape with the honey oil you can place the end cap with around five holes in the end of the pipe. Make sure it is pushed into the pipe so it’s a snug fit and won’t fall off. This will be placed at the bottom of the pipe.

Step 4

From the top you now pour in the material from your marijuana plants which is already crushed from (through a grinder preferably) to a very small size. Ideally you will fill the pipe but not to the point where it is packed too tight. Make sure you don’t use more than an ounce of marijuana at a time.

Step 5

Put the other end cap on the top of the pipe now and make sure it gets pushed in and is tightly fitted.